Fiberglass doors are usually sturdy. However, these doors could damage or get scratched over time. When damaged, its repairing process is an easy one as long the as proper guidelines are followed. You can rectify cracks on your fiberglass door by making use of individual compounds or solutions that are specially produced for it. This process needs to be carried out in the right manner, to make sure that it has a smooth finishing, both in its appearance and texture. Fiberglass doors repair in Toronto, gta area is a natural process than one can imagine. Below are the steps:

Locating the Damage

This is the first step. It involves knowing the actual point where the problem occurred. Most times, the crack is not always apparent to the eye, so you must pay individual attention, as to locate this crack quickly. You can do this by making use of a hard object to gently tap on the fiberglass surface.

Eliminate the Damage

This is the second step. It involves cutting out the whole part that is damaged. This procedure is carried out with a grinder, with the cutting carried out at an angle. This step is an integral one because it helps to enable new patches sticking to the fiberglass.

Clean the Repair Area

This is the third step. It involves making use of a solvent in cleaning the part where the cut was made. This cleaning helps to remove dirt which was left behind.

Pasting Waxed Backer

This is the fourth step, which involves the application of a waxed breaker. The goal is to provide a level surface where you can work on when either the repairing or patching process starts on the door.

Cutting the Fabric

This is carried out after measuring the size of the hole as to result in an excellent fit the moment it is placed on the door. It is recommendable to come up with several layers, but it shouldn’t be more than four as it would have an effect of manufacturing a poor finish. After this, a resin (epoxy) is applied to help join the mat and the fabric which was cut together. Lamenting resin could be much preferable due to its stronger bond.

Harden the Resin

It is crucial to go through provided instructions to know if a different chemical is to be combined as a catalyst to harden the resin. At this stage, the provided instructions from the manufacturer is a crucial component. When done, you can remove air bubbles in the resin by making using of a resin roller.

Removing Wax Backer

This is the final touch. When you are done, you will then need to remove the wax backer which was applied carefully. It should be a seamless result. However, there might be a slight case of imperfection which can be handled easily by using a gel coat to fill them.